EasyManua.ls Logo

Dell POWEREDGE 4300 - Additional Information

Dell POWEREDGE 4300
161 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installing and Configuring SCSI Drivers 3-21
To install the IntranetWare Support Pack 5, follow these steps:
1. Start IntranetWare.
2. Load the Support Pack file onto a workstation that is attached to the PowerEdge
server.
3. Copy the Support Pack file to a volume on the server.
4. Expand the file by typing iwsp5b.exe, and press <Enter>.
5. Follow the directions in the iwsp5b.txt file included with the Support Pack.
When Support Pack 5 has been applied, you can install SMP on your system.
,QVWDOOLQJ6036XSSRUW
NOTE: Before symmetric multiprocessing (SMP) can be installed on your system, you
must
apply the IntranetWare Support Pack 4 or later to the IntranetWare operating
system. See “Installing the Dell-Supplied Novell Patches and Support Pack 5” found
earlier in this chapter.
To add SMP support to your IntranetWare installation, follow these steps:
1. Start IntranetWare.
2. At the IntranetWare console prompt, type Load install and press <Enter>.
3. At the installation screen that appears, select Multi CPU Options and press
<Enter>.
4. At the SMP Installation Options screen, select Select a Platform Support-
Module and press <Enter>.
5. At the Select a Driver screen, select MPS14.PSM and press <Enter>.
A confirmation screen asks if you want to load the selected module.
6. Select Yes and press <Enter>.
A message screen appears.
7. Press <Enter> to continue and then <Alt><Esc> to exit to the console prompt.
8. Type down to down the server and then exit to exit to MS–DOS.
9. Reboot the system to enable SMP support.
8VLQJVWDUWXSQFIDQGDXWRH[HFQFI
The startup.ncf and autoexec.ncf files contain a set of commands that are executed
during the boot routine. The startup.ncf file contains commands to load the disk driv-
ers. Once startup.ncf loads disk drivers, control is passed to the autoexec.ncf file to
complete the boot routine. For additional information on the startup.ncf and
autoexec.ncf files, refer to your IntranetWare documentation.
33255bk0.book Page 21 Tuesday, August 25, 1998 8:46 AM

Table of Contents

Other manuals for Dell POWEREDGE 4300

Related product manuals