Installing and Configuring SCSI Drivers 3-17
Follow these steps only if you are upgrading to IntranetWare or installing it for the first
time:
1. Make backup copies of all IntranetWare diskettes and use those backup copies as
your working diskettes.
2. Start up the server.
3. Insert the Novell IntranetWare CD into the CD-ROM drive.
4. Change to the CD-ROM drive prompt.
The installation files are located in the root directory on the CD-ROM drive.
5. Type install and press <Enter>.
6. Select a language at the language selection screen and press <Enter>.
7. Read and accept the license agreement to continue installation.
8. Select NetWare Server Installation as the type of installation and press
<Enter>.
9. Select NetWare 4.11 as the product to install and press <Enter>.
10. Press <F1> to view detailed explanations of the installation and upgrade options,
select between a simple or custom installation, and press <Enter>.
11. When prompted, type a name for the server and press <Enter>.
12. When prompted to install NetWare symmetric multiprocessing (SMP), select No
and press <Enter>.
NOTE: Even if you plan to install IntranetWare SMP, select
No
at this screen. The
IntranetWare Support Pack 4 or later must be applied before IntranetWare SMP
can be installed. To apply IntranetWare Support Pack 5, see “Installing the Dell-
Supplied Novell Patches and Support Pack 5” found later in this section.
The system searches for existing device drivers and hardware.
13. Press <F3> to continue through the next few screens until the Choose the
Server Drivers screen appears.
14. Select Select/Edit Disk or LAN drivers and press <Enter>.
15. Select Disk and CD-ROM Drivers as the type of driver to install and press
<Enter>.
A list of installed drivers appears.
NOTE: Do not use the SCSI driver for the AIC-7860 host adapter that appears in
the list of installed drivers.
33255bk0.book Page 17 Tuesday, August 25, 1998 8:46 AM
To Next Page
Loading...
