EasyManua.ls Logo

Dell POWEREDGE 4300 - Page 64

Dell POWEREDGE 4300
161 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-26 Dell PowerEdge 4300 Systems Users Guide
Specific error codes, such as those in the following subsections, appear only if you
have installed the host adapters and drivers that generate them.
1RQ²+RVW$GDSWHU6SHFLILF(UURU&RGHV
The following error codes alert you to error conditions caused by factors not related to
the host adapter:
000 Failed ParseDriverParameters call
A call to IntranetWares ParseDriverParameters routine has failed for some unknown
reason. The command line contains errors, or you pressed <Esc> at the port or slot
prompt.
001 Unable to reserve hardware, possible conflict
The driver failed in its attempt to reserve the host adapter’s hardware settings (that is,
direct memory access [DMA] and interrupt request [IRQ] settings). Another card in
your system may be causing a conflict with the host adapter.
002 NetWare rejected card Failed AddDiskSystem call
The driver failed in its attempt to register the host adapter with IntranetWare. The file
server may not have enough memory.
003 Invalid command line option entered > option
An invalid option was entered on the command line. The invalid option that was
entered is displayed.
004 Invalid command line, please enter correctly
The driver was unable to understand the command line options you entered. Be sure
you have entered these options correctly.
+RVW$GDSWHU6SHF LILF(UURU&RGHV
The following error codes alert you to error conditions caused by factors related to the
host adapter:
200 No host adapter found for this driver to register
No Adaptec 78
xx
host adapter was found in your system for the driver to register. Be
sure the host adapter is properly configured and properly seated in the slot.
203 Invalid ‘device’ setting
You have entered an invalid slot setting on the command line. You can only enter slot
numbers for valid host adapters. If you load without the slot option, you will be
prompted to enter a valid value.
204 Invalid ‘verbose’ setting, use ‘y’
You can only enter y for this option (verbose=y).
205 Invalid ‘removable’ setting, use ‘off’
You can only enter off for this option (removable=off).
33255bk0.book Page 26 Tuesday, August 25, 1998 8:46 AM

Table of Contents

Other manuals for Dell POWEREDGE 4300

Related product manuals