Dell POWEREDGE 4300 - Page 91

Using the Resource Configuration Utility 5-9
)LJXUH9LHZRU(GLW'HWDLOV6FUHHQ([DPSOH
The RCU lets you set a variety of system options through the .sci file. Through this
file, you can notify the system of changes to your hardware and memory configura-
tion, manage input/output (I/O) ports, and set other system operating parameters.
Some options reflect installed hardware detected by the system. These items are dis-
played for your information only; you cannot change them through the utility.
NOTE: Whenever you add an expansion card to the computer, its presence is
reflected by changes to the screen shown in Figure 5-1.
RS-232 COM Port 1 IRQ 4 PORT 3F8h-3FFh
RS-232 COM Port 2 IRQ 3 PORT 2F8h-2FFh
Parallel Port DMA 1 IRQ 7 PORT 378h-37Fh
Floppy Controller Enabled
Mouse Controller Enabled
PCI1 - Intel Fast Ethernet LAN Controller
PCI Function 1 Enabled
PCI3 - Adaptec Ultra/Ultra Wide SCSI Ctrlr
PCI Function 1 Enabled
PCI/ISA5 - PowerEdge RAID II Adapter
PCI Function 1 Enabled
Embedded - PCI Host Bridge
PCI Function 1 Enabled
Embedded - PCI PCI Bridge - Bus 1
PCI Function 1 Enabled
Bus 1,0 - PCI VGA Controller
PCI Function 1 Enabled
Standard VGA Resources Enabled
Embedded - DEC PCI-PCI Bridge (21152) - Bus 7
PCI Function 1 Enabled
Bus 2,4 - Adaptec AIC-7890 SCSI Ctrlr
PCI Function 1 Enabled
Bus 2,6 - Adaptec AIC-7860 SCSI Ctrlr
PCI Function 1 Enabled
System - Dell System PowerEdge 4300
33255bk0.book Page 9 Tuesday, August 25, 1998 8:46 AM