Dell POWEREDGE 4300 - Page 95

Using the Resource Configuration Utility 5-13
3. Select the card(s) you want to unlock and press <Enter>.
4. Press <F10> to exit the Advanced menu.
5HPRYLQJD&DUG7KDW&RQIOLFWV:LWKWKH&DUG<RX-XVW
,QVWDOOHG
If there is a resource conflict between two ISA expansion cards and you want to
remove the card that conflicts with the one you just installed, use the following
procedure:
1. From the Steps in configuring your computer menu, select Step 2: Add or
remove boards and press <Enter>.
From the list of expansion slots and cards, select the card in conflict with the one
installed, and press <Del>. When the utility asks you to confirm your command,
press <Enter>. Then press <Esc> to return to the Steps in configuring your
computer menu.
2. Select Step 5: Save and exit and press <Enter>.
3. Select Save the configuration and restart the computer, and press <Enter>.
The system reboots with the new system configuration information.
4. If you deleted an expansion-card configuration file from the previously saved system
configuration information, remove the card from your computer.
For instructions on removing the expansion card, see “Removing an Expansion
Card” in Chapter 8 of the
Installation and Troubleshooting Guide
.
33255bk0.book Page 13 Tuesday, August 25, 1998 8:46 AM