Figure 35. Installing the heat sink
1. retention screw (4) 2. heat sink
3. processor shield 4. retention screw slot (4)
Figure 36. Installing the 165 W heat sink
1.
heat sink 2. retention screw (4)
3. processor shield 4. retention screw slot (4)
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the processor information matches the new system
configuration.
3. Run the system diagnostics to verify that the new processor operates correctly.
96
Installing and removing system components
To Next Page
Loading...
