Dell PowerEdge H730P - Displaying Boot Drive for the Controller; Syntaxdescription; Result; Setting Virtual Drive as Boot Drive

Secured = Yes
Locked = No
Needs EKM Attention = No
PI Eligible = Yes
Drive is formatted for PI = Yes
PI type = 2
Number of bytes of user data in LBA = 4 KB
Certified = Yes
Wide Port Capable = No
Port Information :
================
--------------------------------------------
Port Status Linkspeed SAS address
--------------------------------------------
0 Active 6.0Gb/s 0x5000c5006b1a4fba
1 Active 6.0Gb/s 0x0
--------------------------------------------
Inquiry Data =
00 00 06 12 8b 01 30 02 53 45 41 47 41 54 45 20
53 54 36 30 30 4d 50 30 30 38 34 20 20 20 20 20
56 42 34 34 53 32 47 30 31 48 35 54 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 43 6f 70 79 72 69 67 68 74 20 28 63 29 20 32
30 31 33 20 53 65 61 67 61 74 65 20 41 6c 6c 20
Displaying Boot Drive For The Controller
Syntax
perccli /c0 show bootdrive
Description
Displays the boot drive for the controller. The boot drive can be a physical drive or a virtual drive.
Result
Controller = 0
Status = Success
Description = None
Controller Properties :
=====================
-----------------
Ctrl_Prop Value
-----------------
BootDrive VD:13
-----------------
Setting Virtual Drive As Boot Drive
Syntax
perccli /c0/v13 set bootdrive = on
95