Dell PowerEdge M1000e - Figure 35. Difference between Passthroughs and Switch Modules; Supported Mezzanine Cards and Switches

Dell
PowerEdge M1000e Technical Guide 44
I/O Modules are used as pairs, with two modules servicing each server module fabric providing a fully
redundant solution. I/O Modules may be passthroughs or switches. Passthrough modules provide
direct 1:1 connectivity from each LOM/mezzanine card port on each server module to the external
network. Switches provide an efficient way to consolidate links from the LOM or Mezzanine cards on
the server modules to uplinks into the customer’s network.
Figure 35. Difference Between Passthroughs and Switch Modules
For more information on the I/O module options, see the PowerEdge M-Series Blades I/O Guide.
9.3 Supported Mezzanine Cards and Switches
Dell supports one mezzanine design standard and one I/O Module design standard for true modular
computing.
The currently supported I/O modules include:
• PowerConnect M6220 Switch; GbE + 10GbE uplinks & stacking
• PowerConnect M6348 Switch; 48 1GbE ports + 10GbE uplinks
• PowerConnect M8024 10Gb Ethernet Switch (SFP+, CX4, & 10Gbase-T uplink module options)
• Cisco® Catalyst® 3032 switch; All 1GbE
• Cisco Catalyst 3130g Switch; All 1GbE + stacking
• Cisco Catalyst 3130x Switch; 1GbE+ 10GbE uplinks & stacking
• Cisco 3130g & 3130x switches can be combined in a stack
• 1Gb Ethernet Pass-Through Module
• 10Gb Ethernet Pass-Through Module (SFP+)
• Brocade® 8Gb Fibre Channel Switch