Installing System Components 71
Opening the System
To upgrade or troubleshoot the system, remove the system cover to gain
access to internal components.
1
Unless you are installing a hot-plug component such as a power supply,
turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2
To remove the system cover, turn the latch release lock counter-clockwise
to the unlocked position. See Figure 3-4.
3
Lift up on the latch on top of the system. See Figure 3-4.
4
Grasp the cover on both sides and carefully lift the cover away from the
system.
Closing the System
1
Lift up the latch on the cover.
2
Place the cover on top of the system and offset the cover slightly back so
that it clears the chassis J hooks and lays flush on the system chassis. See
Figure 3-4.
3
Push down the latch to lever the cover into the closed position.
4
Rotate the latch release lock in a clockwise direction to secure the cover.
book.book Page 71 Sunday, June 21, 2009 5:16 PM
To Next Page
Loading...
