88 Installing System Components
Figure 3-6. Installing a Hard Drive Into a Drive Carrier
Installing a Hard Drive Into a Hard-Drive Carrier
1
Insert the hard drive into the hard-drive carrier with the connector end of
the drive at the back. See Figure 3-6.
2
Align the holes on the hard drive with the back set of holes on the hard
drive carrier.
When aligned correctly, the back of the hard drive will be flush with the
back of the hard-drive carrier.
3
Attach the four screws to secure the hard drive to the hard-drive carrier.
1 drive carrier 2 screws (4)
3 hard drive 4 SAS/SATA screw hole
4
3
1
2
book.book Page 88 Tuesday, March 31, 2009 5:26 PM
To Next Page
Loading...
