Dell PowerEdge R720xd - Installing a 2.5 Inch Hard-Drive Blank; Removing a 2.5 Inch Hard-Drive Blank (Back)

Figure 19. Removing and Installing a 2.5 Inch Hard-Drive Blank
1. hard-drive blank
2. release button
Installing A 2.5 Inch Hard-Drive Blank
1. If installed, remove the front bezel.
2. Insert the hard-drive blank into the hard-drive slot until the release button clicks into place.
3. If applicable, install the front bezel.
Removing A 2.5 Inch Hard-Drive Blank (Back)
NOTE: This procedure applies only to PowerEdge R720xd.
CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks installed.
Pull the hard-drive blank out until it is free of the hard-drive slot.
Figure 20. Removing and Installing a 2.5 Inch Hard-Drive Blank (Back)
1. hard-drive blank (back)
52