Dell PowerEdge T160 - Chapter 2: Dell Poweredge T160 System Overview

Dell PowerEdge T160 system overview
The PowerEdge T160 system is a single-socket 3U tower server that supports:
● One Intel® Xeon® E-2400 series processor with up to eight cores or Intel® Pentium® G7400/G7400T processor with up to
two cores
●
Four ECC UDIMM slots
● One Cabled AC power supply unit
● Up to 3 x 3.5-inch cable SATA HDD/SSD from chipset
● Up to 3 x 3.5-inch cable SAS/SATA HDD/SSD from PERC
● Up to 3 x 3.5-inch + 2 x 2.5-inch cable SATA HDD/SSD from chipset
● Up to 3 x 3.5-inch + 2 x 2.5-inch cable SAS/SATA HDD/SSD drives from PERC
NOTE: All instances of SAS and SATA drives are referred to as drives in this document, unless specified otherwise.
NOTE: The Dell PowerEdge T160 system supports speeds of 12 Gbps for SAS3 and 6 Gbps for SATA. The drive speed is
determined by the controller's capability.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
Topics:
• Front view of the system
• Rear view of the system
• Inside the system
• Locating the Express Service Code and Service Tag
• System information Booklet
2
Dell PowerEdge T160 system overview 7