Figure 41. Installing the heat sink
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
3. While booting, press F2 to enter System Setup and check that the processor information matches the new system
configuration.
4. Run the system diagnostics to verify that the new processor operates correctly.
Expansion cards and expansion card risers
NOTE:
When an expansion card is not supported or missing, the iDRAC and Lifecycle Controller logs an event. This does
not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the PowerEdge Servers Troubleshooting Guide at PowerEdge Manuals.
Expansion card installation guidelines
The following table describes the supported expansion cards and riser configurations:
The T160 has a no riser option. Shown below are the PCIe slot offerings for the platform.
76
Disassembly and reassembly
To Next Page