Troubleshooting 11
Network Configuration Assistant (NETCA)
NETCA fails, resulting in database creation errors
NETCA fails because the public network, hostname, or virtual IP is not listed
in the /etc/hosts.equiv file.
Before launching NETCA, ensure that a hostname is assigned to the public
network and that the public and virtual IP addresses are listed in the
/etc/hosts.equiv file.
NETCA cannot configure remote nodes or a RAW device validation error
occurs while running DBCA
This issue occurs when the /etc/hosts.equiv file either does not exist or does
not include the assigned public or virtual IP addresses.
Verify that the /etc/hosts.equiv file on each node contains the correct public
and virtual IP address. Try to rsh to other public names and VIP addresses as
the user oracle.
Cluster Ready Services (CRS)
CRS fails prematurely when trying to start
Refer Oracle Bug 4698419. See the My Oracle Support website at
support.oracle.com.
Apply Patch 4698419 available on the My Oracle Support website at
support.oracle.com.
The Oracle Clusterware installation procedure fails
The Oracle Clusterware installation fails because the EMC PowerPath device
names are not uniform across the nodes.
Before you install Oracle Clusterware, restart PowerPath and ensure that the
PowerPath device names are uniform across the nodes.
To Next Page
Loading...
