Information Update
This document describes important product information and restrictions for the Dell PowerVault MD3260/MD3260i/
MD3660i/MD3660f/MD3060e Storage Arrays.
NOTE: Henceforth in this document, Dell PowerVault MD3260/MD3260i/MD3660i/MD3660f/MD3060e Storage Arrays
is referred to as PowerVault MD Series Dense storage arrays.
PowerVault MD Dense Storage Arrays Software Installation
Requirements
NOTE: If you have an earlier version of MD Storage Manager installed on your system, you must uninstall the older
version before installing the latest version of the MD Storage Manager available on the Resource Media.
Required Resource Media Version
To use the Dell PowerVault MD3260/MD3260i/MD3660i/MD3660f/MD3060e storage arrays, you must install the MD
Storage Manager from the Resource Media for Dell PowerVault MD Series shipped with the system.
CAUTION: Do not install software, utilities, or device drivers from any earlier versions of MD Series Resource
Media.
DVD Name Version
Resource Media for Dell PowerVault MD Series
Systems Supported:
MD3060e, MD3260, MD3260i, MD3660i, and MD3660f
Storage Arrays
A00
Required RAID Controller Module Firmware And NVSRAM Versions
All RAID controller modules in your MD Dense storage array must have the following controller firmware and NVSRAM
versions installed.
Component Version
RAID controller firmware 07.84.00.64
NVSRAM N26X0-784890-904
Always refer to the
Dell PowerVault MD3260, MD3260i, MD3660i, MD3660f, and MD3060e Series Storage Arrays Support
Matrix
at support.dell.com/manuals for the latest required software and/or driver levels.
For information on updating your RAID controller firmware or checking your current firmware levels, see the
Dell
PowerVault MD3260/3260i/3660i/3660f/3060e Storage Arrays Administrator's Guide
at support.dell.com/manuals.
New Features In This Release
This release supports several new hardware and software features. It also includes a redesigned version of the MD
Storage Manager user interface.
5
To Next Page
Loading...
Need help?
General