Need help?Do you have a question about the Dell External M1000e t and is the answer not in the manual?
General| Rack Units | 10U |
|---|---|
| Model | M1000e |
| Power Supply | Up to 6 power supply units (PSUs) |
| Form Factor | Enclosure |
| Cooling | Redundant, hot-swappable fans |
| Management | Dell Chassis Management Controller (CMC) |
| Compatibility | Dell PowerEdge blade servers |
| Networking | Fibre Channel, InfiniBand |
Guides users through setting up CMC network settings via the LCD module, including DHCP or static IP configuration.
Describes the Chassis Management Controller (CMC) module and its system management functions.
Explains how to configure the CMC's network settings, defaulting to DHCP and the process for setting a static IP address.
Details the process of configuring CMC network settings using the enclosure's LCD interface and wizard.
Provides instructions for accessing and logging into the CMC via a web browser, including default credentials and URL.
Guides on configuring iDRAC network settings for server blades using the CMC's web-based interface.
Details how to manage and configure power controls for the enclosure using the CMC, optimizing power consumption.
Provides instructions for downloading and updating the firmware for the CMC module.
Explains how various mezzanine cards and LOMs map to I/O module ports for full-height blades.
Illustrates I/O module port mapping for full-height blades using quad-port mezzanine cards.
Explains LOM and network daughter card port mapping for half-height blades.
Provides step-by-step instructions for safely removing and installing server blades.
Detailed guide on how to install a new server blade into the enclosure bay.
Information on power supply modules, including AC and DC types, removal, and installation.
Instructions for removing and installing fan modules, emphasizing the need for continuous cooling.
Procedures for removing and installing the Chassis Management Controller (CMC) module.
Instructions for removing and installing the iKVM module.
Steps to take when troubleshooting a damaged enclosure, checking component installation and connections.
Procedure for handling and troubleshooting an enclosure that has been exposed to liquid.
Steps for diagnosing and resolving issues with power supply modules.
To Next Page