Dell PowerVault MD3200i - Step 7: Connect to the Target Storage Array from; He Host Server

70 Appendix—Manual Configuration of iSCSI
discovery.sendtargets.auth.username = iqn.1984-
05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in =
test1234567890
If you are using SUSE Linux Enterprise Server SP3 using the GUI:
1
Click Desktop  YaS T  iSCSI Initiator .
2 Click Service Start , then select When Booting .
3 Select Discovered Targets , then select Discovery .
4 Enter the IP address of the port.
5 Click Next .
6 Select any target that is not logged in and click Log in .
7 Select one:
• If you are not using CHAP authentication, select
No Authentication .
Go to step 8.
or
• If you are using CHAP authentication, enter the CHAP user name and
password. To enable Mutual CHAP, select and enter the Mutual
CHAP user name and password.
8 Repeat step 7 for each target until at least one connection is logged in for
each controller.
9 Go to Connected Targets .
10 Verify that the targets are connected and displays a status of true .
Step 7: Connect to the Target Storage Array From
the Host Server
If you are using Windows Server 2008 GUI:
1
Click Start  Programs  Microsoft iSCSI Initiator or click Start  All
Programs
 Administrative Tools  iSCSI Initiator .
2 Click the Tar ge ts tab.
If previous target discovery was successful, the iqn of the storage array
should be displayed under Targets.
book.book Page 70 Sunday, September 11, 2011 10:24 PM