Managing the SMI-S Provider 15
3
Managing the SMI-S Provider
Starting and Stopping the OpenPegasus CIM Server
Windows-Based Operating Systems
To start or stop the OpenPegasus CIM server:
•Open the
Services
window and locate the
cimserver
service. Right-click
cimserver
service and select
start
or
stop
.
Or
• In the command prompt type:
net start cimserver
to start a service
net stop cimserver
to stop a service
Linux-Based Operating Systems
To start or stop the OpenPegasus CIM server, on a terminal window type:
cimserver
to start a service
cimserver -s
to stop a service
Adding or Removing a Storage Array From the
SMI-S Provider
During installation, you are prompted to enter the IP addresses into a file.
After this initial setup, the SMI-enabled client must use the SMI-S Provider
proxy server system management profile to add or remove devices.
NOTE: When a storage array is added, the IP address of only one of the
management ports of the storage array must be supplied (and not both
management ports). Entering the IP addresses for both management ports of a
single storage array causes unpredictable behavior of the SMI-S Provider.
book.book Page 15 Thursday, February 10, 2011 12:14 PM
To Next Page
Loading...
