Dell PowerVault Storage Area Network - Page 13

Error
Code
Issue Description Workaround/Solution
• --tcp_dump— Collect tcp
dump report.
The auto_diags option is hidden since
this is a very special use case.
[--logs] [--cores]
[--tcp_dump] [--all]
14949 CLI expansion license was
showing up as “In Use: No”
even though the expansion
license was installed.
Corrected the CLI command system --
show --license –verbose to
display the license in the correct state.
[root@swsys-221 ~]#
system --show --
license --verbose
Feature ID: 3
Description: 27TB
Status: Enabled
Entitlement ID:
Start Date:
End Date:
Is Eval: No
In Use: Yes
14897 OST limiter throughput
below the set value.
The throttling speed limits that can be set
using the DR Series system CLI
commands (replication --limit
--speed) would not match the set
replication bandwidth limits.
Corrected some minor issues with
the OST limits to correct this issue.
14889 Add the option to the CLI to
show if the SNMP Trap’s
email is on or off.
Added additional option to alerts --
show –email command.
Email SNMP Trap's : Yes or
No
Added additional option to
alerts --show –email
command to show status of Trap’s
e-mail.
14845 system --upgrade fails with
error message "Upgrade
image not found".
After replacing a hardware CRU or FRU,
the DR may come up in support mode with
a request to upgrade the hardware.
The GUI and CLI now place the
uploaded SW package into the
same directory so upon HW
replacement this same image can
be utilized to upgrade the new
component when necessary with
no special user action required.
14724 Replication speed limits not
throttling as expected.
The throttling speed limits that can be set
using the DR Series system CLI
commands (replication --limit
--speed) would not match the set
replication bandwidth limits.
Corrected some minor issues with
the replication limits to correct this
issue.
13537 DR4100 system enclosure
hot add fails in Release 2.0.
Attempting to perform a "hot add" of an
external expansion shelf enclosure in a
DR4000 or DR4100 system fails because
this is not a supported method of
operation in the 2.0 product release. To
prevent this error/failure condition from
occurring, observe the following best
practice:
The workaround is to observe the
following best practice for
connecting an external expansion
shelf enclosure to a Release 2.0
DR4000 or DR4100 system:
• Power off the DR4000 or
DR4100 system (this is a
requirement for 2.0 with
Dell OpenManage 7.1).
13