Dell PowerVault Storage Area Network - Page 59

59 Setting up NetVault Backup Native Virtual Tape Library on the Dell™ DR4X00 Disk Backup
Appliance
if [[ -z "${media_prefix}" ]]
then
echo "That was empty, try again."
else
if [ $media_prefix = "." ]
then
echo "Exiting..."
exit 0
fi
echo "Executing now...with $media_prefix"
break
fi
done
# End of the loop
nv_home=`head -n -1 /etc/.nv6_home`
nvutil=$nv_home/util
logfile=/tmp/logddclean.log
rm -rf /tmp/mediapurge
# ================================================
# Grab media info on tapes in the VTL
# ================================================
$nvutil/nvreport -class media -exclude "%Librarystatus = Online" -format "%label" -sort "%label" | grep $media_prefix >
/tmp/mediapurge
echo "===================================="
echo "Processing the following media list:"
echo "===================================="
cat /tmp/mediapurge|awk '{print $1}'
read expired_media < /tmp/mediapurge
# ================================================
# Create an array and throw data into it
# Run commands against the data in the array
# ================================================
#Open file for reading
exec 10</tmp/mediapurge
let count=0
while read LINE <&10; do
media[$count]=$(echo $LINE | awk '{print $1}')
tempstring=${barcodes[$count]}
barcodes[$count]=${tempstring%" "}
media_avail[$count]=$LINE
((count++))
done
array_num_avail=0
while [ $count -gt 0 ]; do
echo "================================================"
echo "Purging Media with label ${media[$array_num_avail]}"
echo "================================================"
sleep 1
echo $nvutil/nvremovemedia -medialabel ${media[$array_num_avail]}
echo "================================================"
$nvutil/nvremovemedia -medialabel ${media[$array_num_avail]}
wait
sleep 2
let array_num_avail=array_num_avail+1
let count=count-1
done
# close file