Steps
1. Insert the intrusion switch into its slot in the chassis.
2. Route the intruder cable through the routing guides on the system board.
3. Connect the intrusion-switch cable to the connector on the system board.
Next steps
1. Install the air shroud.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Internal hard-drive cage
Removing the internal hard-drive cage
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
4. Remove the 2.5-inch hard-drive assembly.
5. Remove the 3.5-inch hard-drive assembly.
About this task
The following images indicate the location of the internal hard-drive cage and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the SATA power-cables and SATA data-cables from the connectors on the system board.
2. Remove the five (#6-32) screws from the hard-drive cage.
3. Slide and remove the hard-drive cage out of the computer.
Removing and installing components
79
To Next Page
Loading...
