Steps
1. Disconnect the PCIe-power cable from the connector on the graphics card.
2. Remove the PCIe-power cables from the PCIe holder.
3. Push the PCIe latch to open the PCIe door.
4. Push the PCIe-holder latch upwards to release the PCIe-card bracket.
5. Lift the graphics card away from the graphics-card slot.
Installing the powered graphics-card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the powered graphics-card and provide a visual representation of the installation
procedure.
66 Removing and installing components
To Next Page
Loading...
