Dell Precision T1600 - Installing the Input;Output Panel

Installing The Input/Output Panel
1. Insert the Input/Output Board into the slot on the chassis front.
2. Slide the Input/Output Board towards the right of the computer to secure to the
chassis.
3. Use a Phillips screwdriver to tighten the single screw securing the Input/Output
Board to the chassis.
4. Thread the Input/Output Board/FlyWire cable into the chassis clip.
5. Connect the Input/Output Board/FlyWire cable to the system board.
6. Install the Front Bezel.
7. Install the Cover.
8. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Input/Output Panel
45