9. Lift the power supply out of the computer.
Related Links
Installing the Power Supply
Installing The Power Supply
1. Place the power supply in the chassis and slide towards the back of the system to
secure it.
2. Use a Phillips screwdriver to tighten the screws securing the power supply to the
back of the computer.
3. Connect the 4-pin power cable to the system board.
4. Connect the 24-pin power cable to the system board.
5. Thread the power cables into the chassis clips.
6. Connect the power cables connected to the hard drives(s) and optical drive(s).
7. Install the Cover.
8. Follow the procedures in After Working Inside Your Computer.
Related Links
Removing the Power Supply
49
To Next Page
Loading...
