Dell Precision T7610 - Removing the Intrusion Switch; Installing the Intrusion Switch; Removing the PCI Card

Removing the Intrusion Switch
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the left cover.
3. Press the intrusion switch release latch and disconnect the connector from the system board.
a. Unroute the intrusion switch cable from the chassis.
4. Push the intrusion switch downwards and remove it from the computer.
Installing the Intrusion Switch
1. Install the intrusion switch into its place holder on the chassis.
2. Route the intrusion-switch cable around the chassis clips and install the connector to the system board.
3. Install the left cover.
4. Follow the procedures in After Working Inside Your Computer .
Removing the PCI Card
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the left cover.
18