Installing the Coin-Cell Battery
1. Place the coin-cell battery into the slot on the system board.
2. Press the coin-cell battery downward until the release latch springs back into place and secures it.
3. Install:
a. cover
b. air tunnel (if available)
4. Follow the procedures in
After Working Inside Your Computer
.
Removing the Heatsink
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the left cover.
3. Disconnect the heatsink fan cable from the system board.
4. Remove the captive screws that secure the heatsink.
25
To Next Page
Loading...
