Back-Panel Ports Connectors (per Storage Controller)
Fibre Channel, iSCSI, or
SAS connectors
Connection to a Fiber Channel fabric, iSCSI network, or a direct connection
to servers with SAS HBAs
Ethernet connectors MGMT: 10 Mbps, 100 Mbps, or 1 Gbps embedded Ethernet port used for
Storage Center management
REPL: 10 Mbps, 100 Mbps, or 1 Gbps embedded iSCSI port used for
replication to another Storage Center
SAS connectors 6 Gbps SAS connectors for SAS port redundancy and additional expansion
enclosures
NOTE: SAS connectors are SFF-8086/SFF-8088 compliant
USB connector
One USB 3.0 connector.
Not for customer use on SCv2000/SCv2020 storage systems.
Serial connector
NOTE: Not for customer use
LED Indicators
Front panel
• One two-color LED indicator for system status.
• One single-color LED indicator for power status.
• Two digit, seven-segment display indicating the storage system ID
number
• ID button with a single-color LED indicating startup and pressed states
Hard drive carrier
• One single-color activity LED
• One single-color LED status indicator per drive
Storage controller
• Two single-color LEDs per Ethernet port indicating activity and link speed
• Four dual-color LEDs per SAS connector indicating port activity and status
• One single-color LED indicating status
• One single-color LED indicating fault
• One single-color LED for identification
• Eight single-color LED for diagnostics
Power supply/cooling
fan
Four LED status indicators for Power Supply Status, AC Fail status, DC Fail
status, and Fan Fail status
Power Supplies
AC power supply (per power supply)
Wattage 580 W (maximum wattage: 584 W)
Voltage 100–240 VAC (7.6–3.0 A)
Heat dissipation SCv2000: 65 W at 230 VAC and 99 W at 115 VAC
SCv2020: 65 W at 230 VAC and 99 W at 115 VAC
40
SCv2000/SCv2020 Technical Specifications
To Next Page
Loading...
