Dell SCv2080 - Page 47

Back-Panel Ports Connectors (per Storage Controller)
SAS connectors 6 Gbps SAS connectors for SAS port redundancy and an additional expansion
enclosure
NOTE: SAS connectors are SFF-8086/SFF-8088 compliant.
USB Connector One USB 3.0 connector used for Storage Center updates
Serial connector
NOTE: Not for customer use.
LED Indicators
Front panel
• One two-digit LCD indicator for Unit ID, error code, and unit location
identifier
• One two-color LED indicator for power status
• One single-color LED indicator for module fault status (enclosure as a
whole)
• One single-color LED indicator for logical fault status (drive, HBA, RAID
controller, and so on)
• One single-color LED indicator for drawer 1 fault status
• One single-color LED indicator for drawer 2 fault status
Drawer
• One single-color LED indicator for sideplane card and power status
• One single-color LED indicator for drawer fault status
• One single-color LED indicator for logical fault status
• One single-color LED indicator for cable fault status
• Six single-color LED indicators for data transfer status
Disk Drive In Carrier
(DDIC)
One single-color LED for drive fault status
6 Gb SAS IO module 14 one-color LED status indicators, four each for the three SAS ports and two
for the module status
Cooling module
• One single-color LED indicator for module status
• One single-color LED indicator for battery fault status (not currently used)
• One single-color LED indicator for fan fault status
Power supply unit (PSU)
• One single-color LED indicator for PSU fault status
• One single-color LED indicator for AC power fault status
• One single-color LED indicator for power status
Power Supplies
AC power supply (per power supply)
Wattage 2.8 kW
Voltage 200–240 VAC (16 A)
Heat dissipation 191-147 W
Input frequency 50/60 Hz
SCv2080 Storage System Technical Specifications
47