Name: Dell SE2417HGX
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

34 | Troubleshooting

No HDMI 2 Cable

The display will go into Power Save Mode in 4 minutes.

www.dell.com/SE2417HGX

Dell 24 Monitor

SE2417HGX

NOTE: This box also appears during normal system operation, if the video cable is

disconnected or damaged.

Turn off your monitor and reconnect the video cable; then turn on both your computer

and the monitor.

If your monitor remains dark after you reconnect the cables, check your video controller and

computer.

Built-in diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if any screen abnormality

you experience is an inherent problem with your monitor, or with your computer and video

card.

NOTE: You can run the built-in diagnostics only when the video cable is unplugged and

the monitor is in self-test mode.

To run the built-in diagnostics:

Ensure that the screen is clean (no dust particles on the surface of the screen).

Unplug the video cable(s) from the back of the computer or monitor. The monitor then

goes into the self-test mode.

Press and hold Button 1 for 5 seconds. A gray screen appears.

Carefully inspect the screen for abnormalities.

Press Button 1 on the bottom of the monitor again. The color of the screen changes to

red.

Other manuals for Dell SE2417HGX

Questions and Answers:

Need help?

Do you have a question about the Dell SE2417HGX and is the answer not in the manual?

General