Dell SE3223Q - Page 56

56 │ Operating your monitor
OSD warning messages
When the monitor does not support a particular resolution mode, the following
message is displayed:
The current input timing is not supported by the monitor display.
Please change your input timing to 3840x2160, 60Hz or any other
Dell 32 Monitor
NOTE: The message may be slightly dierent according to the
connected input signal.
This means that the monitor cannot synchronize with the signal that it is receiving
from the computer. See Resolution specifications
for the Horizontal and Vertical
frequency ranges addressable by this monitor. The recommended resolution is
3840 x 2160.
Before the DDC/CI function is disabled, the following message is displayed:
The function of adjusting display setting using PC application will be
disabled.
Do you wish to disable DDC/CI function?
Yes
No
Dell 32 Monitor
SE3223Q
When the monitor enters the Standby Mode, the following message appears:
Dell P2418HZ
Dell 32 Monitor
Going into Standby mode...
SE3223Q