Dell Studio XPS 9100 - Power Button Module; Removing the Power Button Module; Replacing the Power Button Module

Back to Contents Page
 Power Button Module
Dell™StudioXPS™9100ServiceManual
Removing the Power Button Module
Replacing the Power Button Module

Removing the Power Button Module

1. Follow the instructions in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the front bezel (see Removing the Front Bezel).

4. Remove the top cover (see Removing the Top Cover).

5. Remove the screw that secures the power button module to the top cover.

6. Press out the securing tab and pull the power button module away from the top cover.

7. Set the power button module aside in a secure location.
Replacing the Power Button Module

1. Follow the instructions in Before You Begin.

2. Align and push the power button module into the slot on the top cover.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
1
screw
2
power button module
3
securing tab
4
top cover