Dell Studio XPS 9100 - Front Bezel; Removing the Front Bezel

Back to Contents Page
 Front Bezel
Dell™StudioXPS™9100ServiceManual
Removing the Front Bezel
Replacing the Front Bezel

Removing the Front Bezel

1. Follow the instructions in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Place the computer in an upright position.

4. Press and hold the front-bezel release clamp and pull the front bezel away from the computer.

5. Disconnect the badge back-light cable from the front bezel.

6. Remove the badge back-light module (see Removing the Badge Back- Light Module).

7. Set aside the front bezel in a secure location.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING: Do not operate your computer with any cover(s) (including computer covers, front bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
1
front-bezel release clamp
2
badge back-light cable
3
front-bezel tabs
4
front bezel
NOTE: Make a note of your computer's Service Tag/Express Service Code located on a label under the FlexBay panel. You will need the Service
Tag/Express Service Code to identify your computer when you access the Dell Support website or contact technical support.