Thunderbolt Security
The settings below configure the Thunderbolt™ adapter security settings within the operating system. Security Levels are not applicable
or enforced in the Pre-boot environment.
• No Security: Automatically connect to devices plugged into the Thunderbolt™ port.
• User Authorization: Approval is required for any new devices connected to the Thunderbolt™ port.
• Secure Connect: The Thunderbolt™ adapter port will only allow connection to devices that have been configured with a shared key.
NOTE: The first time a Thunderbolt peripheral’s Unique ID is granted “always connect” PCIe access, a secure encrypted
key is written to the peripheral controller’s non-volatile memory and added to the host PC’s ACL list. Each time a
peripheral’s Unique ID is found on the ACL, the PC’s controller sends a security challenge and the response from the
peripheral is then verified before the PCIe connection is allowed. If the response is not valid, the user receives a
connection permission prompt. This capability, when enabled, prevents pre-SL2 capable peripherals from connecting to a
PC; thereby preventing a potential HW spoofing of an approved device to generate a DMA exploit (beyond what is
prevented with SL1).
• DisplayPort Only: Automatically connect to DisplayPort devices only. No Thunderbolt™ adapter or PCIe devices are allowed to
connect.
In the BIOS of a Dell Thunderbolt-enabled PC, you will be able to configure the security settings of the Thunderbolt connection. You can
find the configuration options in the BIOS path: System Configuration > USB / Thunderbolt Configuration.
No security Allow legacy Thunderbolt devices to auto-connect – the CM auto
connects a new device plugged in.
User Authorization Allow User Notification devices at minimum –the CM requests
connection approval from the host SW and auto-approval may be
given based on the Unique ID of the connecting device.
Secure Connect Allow one-time saved key devices at minimum – the CM requests
connection approval from the host SW and auto-approval is only
given if the host challenge to the device is acceptable.
DisplayPort Only Allow DisplayPort sinks to be connected (re-driver or DP tunnel, no
PCIe tunneling).
Thunderbolt Settings and Security Options 17
To Next Page
Loading...
