Dell U2412M - Attaching Monitor Stand

Back to Contents Page

Setting Up the Monitor
Dell™U2412MMonitorUser'sGuide
Attaching the Stand
Connecting the Monitor
Organizing Your Cables
Attaching the Soundbar (optional)
Removing the Stand
Wall Mounting (Optional)
Attaching the Stand
To attach the monitor stand:
1. Remove the cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
3. Press the stand till it snaps into its place.
Connecting Your Monitor
To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
NOTE: The stand is detached when the monitor is shipped from the factory.
NOTE: This is applicable for a monitor with a stand. When any other stand is bought, please refer to the respective stand setup guide for set up
instructions.
WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.
Connect the blue (VGA) cable from your monitor to your computer.

NOTE: If your computer supports a white DVI connector, connect the white DVI cable to the monitor and the white DVI connector
on your computer.