Installing the Speakers
1. Insert the speakers into the slot on the computer chassis.
2. Route the speaker cable along the routing channel.
3. Connect the speaker cable to the connector on the system board.
4. Install the:
a. hard drive.
b. battery.
c. back cover.
5. Follow the procedure in After Working Inside Your computer.
Removing the Heat Sink
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
a. back cover.
b. battery.
3. To remove the heat sink:
a. Lift up the plastic flap that covers the memory module to access the heat sink module [1].
b. Remove the screws that secure the heat sink module to the computer chassis [2] [3] [4] [5] [6] [7].
c. Remove the heat sink module from the slot on the system board [8].
Installing the Heat Sink
1. Place the heat sink module into its slot on the system board.
2. Tighten the screws to secure the heat sink module to the computer chassis.
3. Close the plastic cover over the memory module.
4. Install the:
a. battery.
b. back cover.
14
To Next Page
Loading...
