Installing the Power Connector
1. Install the power connector into the slot on the computer chassis.
2. Connect the power connector cable to the system board.
3. Install the:
a. display assembly.
b. heat sink.
c. WLAN card.
d. battery.
e. back cover.
4. Follow the procedure in After Working Inside Your computer.
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. back cover
b. battery
c. display assembly
d. display bezel
3. Disconnect the camera cable and lift the camera to remove it from the computer.
20
To Next Page
Loading...
