About this task
Steps
1. Align the tabs on the battery with the slots on the palm rest assembly.
NOTE:
When installing the battery into the system, insert the tab at the bottom left corner of the battery into the hook
on the bottom side of the palm rest.
2. Replace the three (M2x3) screws that secure the battery to the palmrest.
3. Reconnect the battery cable to the connector on the system board.
NOTE:
When installing the battery into the system, insert the tab at the bottom left corner of the battery into the hook
on the bottom side of the palm rest.
Next steps
1. Install the base cover.
2. Install the SD card.
3. Follow the procedure in after working inside your computer.
Disassembly and reassembly
29
To Next Page
Loading...
