3. Install the system fan.
4. Install the memory
5. Install the SSD.
6. Install the WLAN.
7. Install the battery.
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in after working inside your computer.
Power-adapter port
Removing the power adapter port
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Remove the base cover.
4. Disconnect the battery cable.
5. Remove the WLAN.
6. Remove the SSD.
7. Remove the system fan.
8. Remove the display assembly.
9. Remove the system board
NOTE: The system board can be removed along with the heat sink.
About this task
78
Disassembly and reassembly
To Next Page
Loading...
