Steps
1. Align the system board on the palm-rest and keyboard assembly.
2. Connect the right speaker cable and left speaker cable to the respective connectors on the system board.
3. Connect the coin-cell battery cable to the connector on the system board.
4. Connect the fingerprint-reader cable, I/O-board cable, touchpad cable, keyboard cable and keyboard-backlit cable to the respective
connectors and close the latch to secure the cables to the connectors on the system board.
Next steps
1. Install the display assembly.
2. Install the solid state drive.
3. Install the heat sink.
4. Install the fan.
5. Install the 4-cell battery.
6. Install the 3-cell battery.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
42
Removing and installing components
To Next Page
Loading...
