About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the touchpad.
2. Install the power-adapter port.
3. Install the display assembly.
4. Install the system board.
5. Install the speakers.
6. Install the wireless card.
7. Install the 4-cell battery.
8. Install the 3-cell battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 4-cell battery.
4. Remove the 3-cell battery.
5. Remove the wireless card.
6. Remove the speakers.
7. Remove the system board.
NOTE: The system board can be removed with the heat sink attached.
44 Removing and installing components
To Next Page
Loading...
