Steps
1. Using the alignment posts, place the left and right speakers on the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4. Connect the touchpad cable and close the latch of the touchpad connector on the system board.
5. Connect the keyboard cable and close the latch of the keyboard connector on the system board.
6. Connect the keyboard backlit cable and close the latch of the keyboard backlit connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing components 47
To Next Page
Loading...
