Dell Vostro A840 - Quick Setup

Display Bezel

Removing the Display Bezel


1. Remove the display assembly (see Display).

2. Remove the four rubber bumpers from the top and mylar tapes from the bottom of the display bezel.

3. Remove the six screws on the display bezel.

4. Using your fingertips, carefully pry up the inside edge of the display bezel.

5. Remove the display bezel.

Replacing the Display Bezel


1. Align the display bezel over the display panel, and gently snap into place.

2. Replace and tighten the six screws.

3. Replace the display assembly (see Replacing the Display Assembly).
Display Panel

NOTICE: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1
rubber bumper (4)
2
screw (6)
3
display bezel
4
display panel
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.