Dell Vostro A840 - Removing the Module Cover; Replacing the Module Cover

Back to Contents Page
 Module Cover
Dell™Vostro™A840/A860ServiceManual
Removing the Module Cover
Replacing the Module Cover


Removing the Module Cover

1. Follow the procedures in Before You Begin.

2. Turn the computer over.

3. Remove the two screws from the module cover.

4. Lift the module cover away from the computer.
Replacing the Module Cover

1. Replace the module cover.

2. Replace the two screws on the module cover.

3. Slide the battery into the battery bay, until it clicks into place.
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
1
module cover screw (2)
2
module cover