Dell Vostro A840 - Removing the Display Panel; Replacing the Display Panel

Removing the Display Panel

1. Remove the display assembly (see Display).

2. Remove the display bezel (see Removing the Display Bezel).

3. Remove the six screws securing the display panel assembly to the display cover.

4. Disconnect the cables from the connectors on each end of the inverter board.

5. Remove the display panel assembly.

6. Remove the eight screws (four on each side) that secure the display panel brackets to the display panel.

Replacing the Display Panel


1. Align the display panel brackets with the display panel.

NOTE: Make a note of the routing of the cables behind the display panel.
1
display panel
2
screw (6)
3
display inverter
4
display cover
1
display panel bracket
(1 left; 1 right)
2
display bracket screw
(8 total; 4 on each side)
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.