Installing The DC-In Port
1. Replace the DC-in port into its compartment.
2. Tighten the single screw to secure the DC-in port in place.
3. Connect the DC-in cable to the system board.
4. Install the
display assembly
.
5. Install the
Wireless Wide Area Network (WWAN) card
.
6. Install the
Wireless Local Area Network (WLAN) card
.
7. Install the
palm rest
.
8. Install the
memory
.
9. Install the
hard drive
.
10. Install the
keyboard
.
11. Install the
base cover
.
12. Install the
Secure Digital (SD) card
.
13. Install the
Subscriber Identity Module (SIM) card
.
14. Install the
battery
.
15. Follow the procedures in
After Working Inside Your Computer
.
69
To Next Page
Loading...
