Item Ports, panels, or slots Icon Description
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press
and hold the system ID button (for more than 5
seconds) to enter the BIOS progress mode.
11 OCP NIC port N/A This port supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
12 NIC port (2) The NIC ports are embedded on the LOM card that is
connected to the system board.
13 BOSS S2 module N/A This slot supports the BOSS S2 module.
For more information, see the Dell VxRail™ E660, E660F, and E660N Technical Specifications.
10 System overview
To Next Page
Loading...
