Steps
To install the display-assembly base, perform all the post-requisite procedures.
Next steps
1. Install the power-button and I/O board.
2. Install the audio board.
3. Install the system board.
NOTE:
The system board can be installed with the memory, solid-state drive(s), coin-cell battery, and processor
pre-attached.
4. Install the heat sink.
5. Install the speakers.
6. Install the I/O bracket.
7. Install the power-supply fan.
8. Install the power-supply unit.
9. Install the fan.
10. Install the retractable-camera assembly.
11. Install the bottom cover.
12. Install the I/O cover.
13. Install the wireless card.
14. Install the system-board shield.
15. Install the back cover.
16. Install the stand.
17. Follow the procedure in After working inside your computer.
104
Removal and installation procedures for High Performance processors
To Next Page
Loading...
Need help?
General