3. Install the battery.
4. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive from M.2 slot, whichever is applicable.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the system board.
NOTE: The system board can be removed with the following components attached:
● heat sink
● fans
● solid-state drive
About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the
removal procedure.
Figure 44. Removing the power button with fingerprint reader
Steps
NOTE:
When removing the power button with fingerprint reader, open the display assembly to a 90-degree angle and then
place the computer on the edge of a flat surface. Ensure to maintain the angle throughout the removal process to minimize
the risk of damaging the thin display panel when applying torque to install and remove screws from the computer.
Removing and installing Field Replaceable Units (FRUs) 63
To Next Page
Loading...
