72 Removing and Installing Parts
5
Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making
internal connections, or otherwise customizing it for your computer.
CAUTION: Some network adapters automatically start the computer when they are connected to a network.
To guard against electrical shock, be sure to unplug your computer from its electrical outlet before installing
any cards.
6
Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
7
If you are installing the card into the x16 card connector, position the card so the securing slot is
aligned with the securing tab, and gently pull the securing tab.
8
Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
9
Before you close the card retention door, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
1 card not fully seated 2 bracket within slot
3 bracket caught outside of slot 4 card fully seated
4
1
2
3
To Next Page
Loading...
