Removing and Installing Parts 81
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the computer cover.
Removing a CD/DVD Drive
1
Follow the procedures in "Before You Begin" on page 61.
2
Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and
the cable connectors.
3
Pull up on the drive release latch and slide the drive towards the back of the computer.
4
Carefully, so as not to damage the attached interface cable, lift the drive away from the computer.
1 drive release latch 2 CD/DVD drive
1
2
To Next Page
Loading...
